AWS B5.1:2013 PDF

AWS B5.1 PDF

Requirements.

This standard establishes the requirements for qualification and defines the body of knowledge applicable to welding inspection personnel.

Levels.

There are three levels of qualification: Associate Welding Inspector (AWI), Welding Inspector (WI), and Senior Welding Inspector (SWI).

Responsibility.

Qualification of AWI/WI/SWI personnel to the requirements of this standard does not eliminate the need of an employer to determine the ability of the individual to perform the duties involved in a particular welding inspection assignment.

Employer.

This standard is intended to supplement the requirements of an employer, code, or other documents, and shall not be construed as a preemption of the employer’s responsibility for the work or for the performance of the work.

Terminology Definitions.

As used in this standard, the word shall denotes a requirement, the word should denotes a guideline, and the word may means it is permissible. As used in this specification the word welders includes welding operators, brazers, and brazing operators.

Units.

This standard does not require units of measure. Therefore, no equivalents or conversions are contained except when they are cited in examples.

Safety

Safety and health issues and concerns are beyond the scope of this standard; some safety and health information is provided, but such issues are not fully addressed herein.

Safety and health information is available from the following sources:

American Welding Society:

(1) ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes

(2) AWS Safety and Health Fact Sheets

(3) Other safety and health information on the AWS website

Material or Equipment Manufacturers:

(1) Material Safety Data Sheets supplied by materials manufacturers

(2) Operating Manuals supplied by equipment manufacturers

Applicable Regulatory Agencies

Work performed in accordance with this standard may involve the use of materials that have been deemed hazardous, and may involve operations or equipment that may cause injury or death. This standard does not purport to address all safety and health risks that may be encountered. The user of this standard should establish an appropriate safety program to address such risks as well as to meet applicable regulatory requirements. ANSI Z49.1 should be considered when developing the safety program.

Referenced Documents

(1) ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes¹

(2) AWS A3.0, Standard Welding Terms and Definitions¹

¹ ANSI Z49.1 and AWS standards are published by the American Welding Society, 8669 NW 36 St, # 130, Miami, FL 33166.