ASTM B952/B952M-19(2024) PDF

ASTM B952/B952M-19(2024) PDF

1.1This specification covers zinc alloys in ingot form for remelting for the manufacture of Spin Castings as specified and designated, as shown in Table 1. Seven alloy compositions are specified, designated as follows:

Common Traditional UNS Spin Casting Alloy SC-A … Z35550 Spin Casting Alloy SC-B … Z35551 Spin Casting Alloy SC-C … Z35534 Spin Casting Alloy SC-D HJ10 Z35547 Spin Casting Alloy SC-E HJ20 Z35548 Spin Casting Alloy SC-F HJ40 Z35552 ZA-73 … Z36500

1.2Zinc alloys #2, #3, #5, and ZA-8 specified in Specification B240 are also used in the spin casting process.

1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.