AS 61000.6.4:2020 PDF

AS 61000.6.4:2020 PDF

This Standard adopts IEC 61000-6-4:2018 modifications for Australia, which provides emission requirements applies to electrical and electronic equipment intended for use within the environment existing at industrial locations.

This Standard was prepared by the Australian members of the Joint Standards Australia/Standards New Zealand Committee TE-003, Electromagnetic Compatibility, to supersede AS/NZS 61000.6.4:2012, Electromagnetic compatibility (EMC)—Part 6.4: Generic standards—Emission standard for industrial environments.

The objective of this Standard is to provide emission requirements applies to electrical and electronic equipment intended for use within the environment existing at industrial locations.

After consultation with stakeholders in both countries, Standards Australia and Standards New Zealand decided to develop this Standard as an Australian Standard rather than an Australian/New Zealand Standard.

This document does not apply to equipment that falls within the scope of AS/NZS 61000.6-3.

The environments encompassed by this document cover both indoor and outdoor locations.

Emission requirements in the frequency range 9 kHz to 400 GHz are covered in this document and have been selected to provide an adequate level of protection of radio reception in the defined electromagnetic environment. No measurement needs to be performed at frequencies where no requirement is specified. These requirements are considered essential to provide an adequate level of protection to radio services.